Review: cheap Chinese gasifying stove

You can tell right away that there’s something different going on there compared to a campfire or hobo (tin can) stove.

There are many producers of the little Chinese stove;  I bought the Ohuhu (???) one, as it has about 1000 reviews with an average of 4.5 stars.

The stove comes packed in a decent little bag, stacked concentrically like a Russian doll.  Took a couple times to eyeball and put together correctly.  Reading the included instructions would have made that part faster.  🙂

The stove is small and uses smaller bits of fuel than one is used to when building open cooking fires.  This is an upside — small pieces that aren’t worth picking up and throwing into an open fire work great in this stove.   Make use of everything!  It’s even loaded opposite to how one builds an open fire:  larger chunks on the bottom and small stuff on top where it’s lit.

I’ve heated water for manna coffee, and done some light cooking on it.  Works great and leaves fine ash and a few bits of char.

The drawback is the same as other bio fires:  soot needs to be cleaned off your cookware afterwards.

Verdict

Totally worth it.  For $20 it’s worth the fun of watching it.  Plus it works great as a stove.

 

 


 

 

 

 

woodgas
from a YT video by Stove Mods

This particular type of gasifying stove (a top lit updraft or TLUD) does burn some wood like a campfire but also has a few tricks up its sleeve.

Based on my observations, it looks to me like the stove runs in three stages.  Hopefully someone with more understanding will jump in with corrections.

  1. When the fire is first started it runs like a campfire.  Not complicated.
  2. As the stove heats up, fresh air starts drawing through the double walls by convection, and is injected into the neck of the stove.  This fresh air allows the burning of combustibles in the  “smokestream”, yielding more heat and reducing smoke.  Some flames still visible near the fuel but top jets are starting to run.
  3. increasing heat starts gasifying the fuel instead of burning it directly (pyrolysis?).    Air becomes very still in the main chamber; condensed woodgas observed around freshly-added fuel is nearly motionless and

 

Once running, it looks to me like the primary combustion burning the fuel is greatly reduced, and the the secondary starts heating the fuel enough that it starts pyrolizing instead of combusting.  I do not observe flames on the fuel after the secondary gets going.

Leave a Reply

Your email address will not be published. Required fields are marked *